Viessmann Modellspielwaren GmbH

Hello!

I need working conductive DCC catenary at N-Scale!
Now i m trying to solder catenary wires to masts.
It's too hard to solder! I sanded it well, and used very aggressive fluxes, but, results is not so satisfactory!
Which flux must i use?
Must i wear off plastic isolators? They melts very fastly!

---------
Thanks,
Vadim

Soldered N-Scale catenary looks like at this photo, and without plastic isolators (i remove it, they melts)



-----------
Vadim