Wiring 5800 and 5100

  • Can some member help me by drawing a schematic on how I would connect a 5100 Bahnschranke and a 5800 Blinkelektronik fur Andreaskreuze with double tracks (Zweigeisige Strecke)


    Thanks you

    Vinicio Pavincich
    Berowra Heights 2082 Australia
    Cell: +61409830330
    Skype: vinpav54


    Fleischmann Twin Centre, RailRoad & Co 7 Silver, Viessmann catenary, signals, signal control modules & occupancy detectors Uhlenbrock loconet switches modules

  • Thank you Jurgen,
    Sorry my layout is HO so article is 5060 not 5800 but manual is the same.
    Figure 3 of the 5060 manual shows brown wire from 5065 goes to point a on the relay 5552 and yellow wires go to same place as the yellow wires of 5100 into relay 5552.


    However, in manual of 5060 on page 3 it says "A combination with Viessmann-barriers.....In this case you don't need any relay for controlling the indicating electronic 5065,.....instructions of the barrier."


    In manual for 5100 there is no mention of wiring the lights with the barrier. Except for Figure 3 on page 4 5100 red contact for blinking unit and on page 6 "The drive units of the HO railroad crossing gates (5100) are including an additional......with the contact of one of the drive units".


    My question is where do I connect these 2 red wires from 5100 to 5065?
    Thank you
    VinP

    Vinicio Pavincich
    Berowra Heights 2082 Australia
    Cell: +61409830330
    Skype: vinpav54


    Fleischmann Twin Centre, RailRoad & Co 7 Silver, Viessmann catenary, signals, signal control modules & occupancy detectors Uhlenbrock loconet switches modules

  • Thank you Jurgen for your prompt support. It was not clear to me and I didnt want to short anything.
    Cheers
    VinP

    Vinicio Pavincich
    Berowra Heights 2082 Australia
    Cell: +61409830330
    Skype: vinpav54


    Fleischmann Twin Centre, RailRoad & Co 7 Silver, Viessmann catenary, signals, signal control modules & occupancy detectors Uhlenbrock loconet switches modules