Control Module 5223 and Uhlenbrock 63410 - Connection

  • Hi,
    Looking for some assistance/advice.
    I’m using a number of Viessmann signal control modules( 5220 – 5223) to which my distant, block, entry and departure signals (all Viessmann) are connected.
    Then , these are connected to Uhlenbrock 63410 modules as the “accessory decoder”. Initially I will use my Twin-Centre to control these until I set them up in my RailRoad and Co software.

    My issue is with the 4 state LED Exit Signals (Licht Ausfahrsignal). The Viessmann Control module 5233 only has 4 outputs 1 each for Hp0, Hp2, Hp1 and Hp0/Sh1. The Uhlenbrock module as input needs 5 wires connected to it – R1, G, Y, W and R2.
    (There is a Viessmann accessory decoder 5211 which only requires the 4 outputs from the 5223 control module as inputs).

    How do I get around this dilemma?
    I can forward the manuals for the Viessmann 5223 module and the Uhlenbrock 63410 module.
    Thanks
    VinP

    Vinicio Pavincich
    Berowra Heights 2082 Australia
    Cell: +61409830330
    Skype: vinpav54


    Fleischmann Twin Centre, RailRoad & Co 7 Silver, Viessmann catenary, signals, signal control modules & occupancy detectors Uhlenbrock loconet switches modules